Support Trans People.

went to the Will Wood Halloween concert. the band just started playing Luigi’s Mansion and everyone proceeded to mosh extremely hard to it and form a dance circle. this went on for several minutes and it was magical I can die happy

It’s time for the yearly ritual

cracking up over this goodwill listing photo

me and my annoying grandchild that I hate

what the hell even is a webp image. i dont care fuck why cant you play nice and just be a png. asshole image

🌟 1998 Furby Re-Lashing Guide 🌟

A visual step-by-step guide to my own process for giving 1998 Furbies lashes that retain the classic look. There may be other guides and methods out there, this is just my own way to do it!

MATERIALS NEEDED:

Detached Eyelids ( guide for removal: CLICK HERE )

13mm D-Curl Lash Extensions ( see photo )*

Mod Podge

Tacky Glue

X-Acto Knife

Small Paint Brush

Q-tip

Lightweight Paper

SHARP Scissors

Clean Water

Washcloth or Paper Towel

Optional, Ruler with cm/mm marks & Marker or Pen * 13mm will be closest to original length, I would not recommend anything longer than 15mm unless you want the lashes to really look insanely long.

I will put all of the steps under the readmore! 👇

Step 1:

Use the x-acto knife to gently peel up an eyelash foil strip, and be careful not to disturb the lashes. Go slowly and only handle the strip by the sticky foil. You will only need one strip for a pair of lashes!

Step 2:

Place the sticky strip on the lightweight paper, I put it close to the edge because it'll be easier to cut out later. Paint a thin layer of Mod Podge over the base of the lashes on the strip to secure them. This is an important step, there isn't much else keeping them in place, otherwise!

It's hard to wait, but let the glue dry before handling the strip again, I suggest a good 30 minutes or so.

Step 3:

Now that the glue has dried, cut out the paper around the strip and very carefully trim the foil and paper at the sides and underneath the curl of the lashes. Do this slowly, so you don't accidentally snip the lashes, you ONLY want to trim back the paper+foil. This will make them appear more flush with the eyelid when glued in.

Step 4:

Optionally, use a ruler to find the center of the strip and mark it with a marker, I used a Sharpie because it dries instantly. It's possible to eyeball this, but I like them to be as even as possible.

Snip the strip in half, very sharp scissors will prevent the foil from bending or warping. Again, be careful not to snip the lashes themselves! It's ok if you lose one or two in this process, as long as they still look relatively clean and even once split.

Step 5:

Apply a drop of tacky glue to the back of each eyelid and use the Q-tip to spread it in a thin, sticky layer. The eyelids have a little trench you can use as a guide for placement.

You can repeat this process if you wish with the top of the lash strip where it will be applied, as well, to make it stick better. I haven't tried this myself, yet.

Place the base of the lash strip over the tacky glue and press it into position, I use the backs of my thumb nails to hold them firmly while the glue sets. It make take some effort and patience to get them to stay in the curve, just try not to slide them around.

Step 6 (Final):

After the tacky glue has had some time to dry, I like to apply a final coat of Mod Podge over the paper and underside of the eyelids to seal and protect everything. Give this 30 minutes to an hour to fully dry before re-assembling your Furby!

✨ Voila! Fresh new eyelashes! ✨

They won't look exactly like the original, but close enough for me. I'm sure the process can be improved in some ways, so if you have any feedback please share it in comments or tags!

Good luck with your projects and thank you for reading! 🌟

Homefry in the snow!

Beach Bear tries to get a new haircut...

i was amazed that this japanese twitter user has figured out 2005 beak repair! (link to OP & original post) they explained in another comment that they use silicone rubber used for sealing/repairing bathroom tiles for the beak! this is all just google translate, but i feel this is REALLY valuable bc ive never seen such a simple but effective way to repair these beaks. details below:

seriously need to test this... this is HUGE

I have a photo like this lol

Little sleepy baby furby milk spilled and sad little sleepy baby furby in little baby Jordan shoes

Chuck E. Cheese’s,Kedzie Ave